Re: ethernet driver problem

To: Roland McGrath <roland@cs.utah.edu>
Subject: Re: ethernet driver problem
From: Rob Savoye <rob@darkstar.welcomehome.org>
Date: Fri, 16 Jul 1999 22:48:37 -0600
Cc: Rob Savoye <rob@darkstar.welcomehome.org>, oskit-users@cs.utah.edu
In-Reply-To: <199907170440.AAA14796@frob.com>; from Roland McGrath on Sat, Jul 17, 1999 at 12:40:17AM -0400
References: <19990716220853.17178@welcomehome.org> <199907170440.AAA14796@frob.com>
Sender: owner-oskit-users@fast.cs.utah.edu

On Sat, Jul 17, 1999 at 12:40:17AM -0400, Roland McGrath wrote:

> The vortex driver in the oskit may be a little questionable.  The tulip and

  Yeah, I saw a post about that, I'm using a more recent Linux one, but it
still doesn't work. The Tulip should work though.

> exact messages you see from the drivers?  (It's easiest to get them all if
> you use a serial console and record it from another machine.)

  Which messages ? I don't get any error messages at all from the driver.
I'm already using the serial console, as well as the GDB support. Here's
the messages I get from OSKit. (minus my own debugging ones)

Calibrating delay loop.. ok - 198.84 BogoMips
BIOS mapped to 0xe0000
pcibios_init : OSKit PCI BIOS revision 1.0
Probing PCI hardware.
Warning : Unknown PCI device (10b7:9001).  Please read include/linux/pci.h 
<= init-driver.c: oskit_linux_init_ethernet() return
Currently registered device drivers:
  tulip           DEC 21040 Ethernet driver
  eepro100        Intel i82557 Ethernet driver
        03:52:56: Probing devices...
Probing tulip
Probing eepro100
eth0: Intel EtherExpress Pro 10/100 at 0xff40, 00:A0:C9:06:BB:57, IRQ 11.
  Board assembly 645520-034, Physical connectors present: RJ45
  Primary interface chip DP83840 PHY #1.
  DP83840 specific setup, setting register 23 to 8462.
  General self-test: passed.
<7>  Serial sub-system self-test: passed.
<7>  Internal registers self-test: passed.
<7>  ROM checksum self-test: passed (0x49caa8d6).
  Receiver lock-up workaround activated.
Current hardware tree:
  isa.isa                     Industry Standard Architecture (ISA) Bus
    0xff40.eepro100           Intel i82557 Ethernet adaptor
        03:52:56: Looking for devices...
        20:45:12: 1 Ethernet adaptor found:
  eepro100        Intel i82557 Ethernet adaptor            00:a0:c9:06:bb:57

  tcpdump also shows it isn't transmitting anything at all. I get similar
stuff when using either the tulip and the vortex drivers.

	- rob -

Follow-Ups:

Re: ethernet driver problem

From: Roland McGrath <roland@cs.utah.edu>

References:

ethernet driver problem

From: Rob Savoye <rob@welcomehome.org>

Re: ethernet driver problem

From: Roland McGrath <roland@cs.utah.edu>