1/ sysop access
---------------

The command SET/SYSop sets callsign for which you want
to permit a sysop access. This command is used according
to the same way than SET/NODE.

SSID is checked if you only define it :

SET/SYS +F5MZN +F6FBB-0 +LA6CU-5

F5MZN : for any SSID
F6FBB : only -0
LA6CU : only -5

Both thenet type and MD2 password are supported.

The whole password are stored in the file system/passwd.dat.
Both user callsign and password are on a single line :

F5MZN	mypassword
F6FBB	hispassword
LA6CU	hispassword


2/ local database
-----------------

Local database are now supported. The file system/local.dat 
contains the local database declaration.

Please consult the version 2 manual to get information about
the local database.

Note :	- BUCKMASTER is not supported yet. 
	- Remote databases are not supported yet.


3/ clulink protocol
-------------------

Some mods in the clulink protocol. See the file CLULINK.TXT.


4/ fixed bugs
-------------

DxNet was sending back to the adjacent his configuration
during the initialization sequence. Fixed.

When a PC17 was coming in for a user not connected or
unknown, the linux version was crashing. Fixed. (Tks
F1TE and F6FBB).

Some strange things may occur with the user config. Fixed. 
Tks F1TE.

Talk protocol wasn't send correctly the BEEP flag. Fixed.
Tks F1TE, F6BEE, and others.


5/ Miscellaneous
----------------

Dx spot checked for dupe.

Pavillon's protocols are checked to see if everything is
correct. A rubbish protocol is trashed. This avoid
crashes and forwarding of bad protocols.

---

I received requests from some of you. I'll try to satisfy
everybody as soon as possible. Thank you for your
comprehension.